Tom Thumb Bit with Copper Lozenge

The Tom Thumb bit is a cross between an American gag and an elevator bit. It offers more precision and control and is very popular for show jumping and cross country. It has a lifting effect in front which can assist the rider in helping to sit the horse back on its hocks, enabling tighter turns and more efficient jumping. The uplifting action combined with poll pressure can also discourage horses from leaning on the bit. Can be used with one rein on either the snaffle ring or the lower ring or alternatively, for increased precision, with two reins.

The lozenge in the centre of this bit contours the shape of the tongue and helps to reduce the nutcracker action of a single jointed bit which helps form a soft contact, allowing clear aids to be given down the reins. Copper is a warm metal which encourages salivation and mouthing on the bit. A useful bit for horses that tend to lean against the riders hands.

Measurements
As per our size guide the A & B measurements of this bit are as follows:
A=16mm
B=135mm

Stainless Steel Horse Bits...
Stainless steel is the most commonly used material for horse bits as it is durable, easy to clean and does not rust. Some of our stainless steel bits feature copper mouthpieces which help to create a warming sensation and encourage the horse to salivate and accept the bit. Stainless steel bits are suitable for a wide range of horses and are available in many designs so that you can choose the right bit for your horse and discipline.

Please note, for reasons of health and hygiene this bit is non returnable if removed from the template.

• Loose ring, shank sides
• Double jointed, stainless steel mouthpiece with copper lozenge
• Can help to lift horses off the forehand
• Exerts poll pressure
• Ideally used by experienced riders
• This bit is NOT BD Legal
• Bit strength: Moderate

To promote good hygiene and protect the longevity of your horse bit we recommend the following care regimen after every use.

1. Rinse your bit after every use under a tap to remove any saliva or debris on the surface.

2. Use a soft sponge or cloth to wipe any excess debris off of the bit, paying particular attention to joins and hinges.

3. Leave to dry naturally.